Our sister company, Utah Window Tint, is going to be featured at the Utah Dream Home Expo this Friday and Saturday, May 10th & 11th at the South Towne Expo Center from 10 a.m till 8 p.m. There will be special, show only discounts available at our booth. Please go to http://www.utahdreamhomeexpo.com to purchase tickets. We hope to see you there!
This customers bed liner is beginning to release from the bed due to poor preparation and bad product. These types of failures require a time consuming, complete removal of the existing bed liner. In some cases you will even need to sandblast the bed to bare metal. Use Turbo Liner first, then never worry about this problem ever again.
We are pleased to announce that our sister company, Utah Window Tint, will be featured at the 2013 Salt Lake Tribune Home & Garden Festival on March 8th through March 10th. Please come and check out their display at Booth 2917. Coupons for our Turbo Liner spray-in bed liner will be available at the booth as well.
Please check out our Specials page to learn more about our Truck Month spray-in bed liner savings.
Cleaning your polyurea bed liner is an easy process. Begin by spraying out your truck bed with a power washer. Next, spray Castrol Super Clean throughout the bed, do some light scrubbing with a stiff brush and wait approximately five to ten minutes. Now, spray the bed out again with a power washer and your bed liner will look as good as new.
*Make sure you are wearing appropriate protective gear if necessary.
Rust prevention in your truck bed starts with a spray-in bed liner. The application of Turbo Liner essentially creates an air and water tight bond. That means you can use the bed of your truck for all of it's intended uses in any type of weather and you will never have to worry about rust or corrosion destroying your investment.
The polyurea in the spray-on bed liner is an elastomer which holds fragments together when applied to the inside of a wall of cementations, wood, and/or metal. It has been installed in some high-profile buildings. The most famous is the United States Pentagon. The spray-on coating product was applied to the inside surface of the exterior walls of the building. If it's good enough for the Pentagon, it will be absolutely amazing in the bed of your truck.
Just like building a house, a good foundation is crucial, especially when you have a spray in bed liner applied. The prep process starts with cleaning the bed out of loose debris. Then we mask the truck off to eliminate over spray. Then we sand the entire surface to be sprayed, and give it an acetone bath. Sanding and an acetone bath create the necessary surface to bond to. Then we spray.